CCIE Pursuit Blog

December 8, 2008

Question Of The Day: 08 December, 2008

***Update 09 December***

Assume that OSPF was configured on the router after any changes were made to the interfaces on R1.

Given the following information:

R1#sh ip int br | e ass
Interface                  IP-Address      OK? Method Status                Protocol
FastEthernet0/0       YES NVRAM  up                    up
Serial0/1              YES NVRAM  up                    up
Loopback0               YES NVRAM  administratively down down

R1#sh run | sec router ospf
router ospf 100
network area 0

Blog at